Water Dispenser Cold Water Sensor for Avalon Brio Primo, 28.5 Inch Probe

상품 특징

• Tools & Home Improvement
• Kitchen & Bath Fixtures
• Kitchen Fixtures
• Water Dispensers & Coolers
• Water Dispenser Replacement Parts
• Image Unavailable Image not available forColor:
• Replacement cold water sensor for Avalon, Brio and Primo bottom load water dispensers. Its 28.5 inch lead routes through the same path as the original probe, so the spare suits the stock tank layout without any rerouting.
• Cools only when the tank needs it. The sensor wakes the compressor once water temperature climbs above the set point and lets it rest after the target temperature returns, keeping your drinking water cold around the clock with no frost buildup or over-chilling.
• Ends the false readings that age a compressor. A steady resistance signal reaches the control board instead of the drifting values a worn sensor sends, so the unit stops short cycling and actually delivers water cold enough to drink.
• Ten minute swap with no tools. Unplug the failed probe from the cold tank port, seat this sensor in the same opening, and push the blue plug back on, which mates one way only so you cannot install it backwards.
• Touches only the cold water side. The sensor takes over the cold tank sensing job while the heating circuit and the rest of the dispenser run untouched, so a single failed part gets replaced without disturbing the unit around it.