Foldable Magnetic Rechargeable Under Hood LED Work Light Bar

상품 특징

• 3800LM FROM 164 WHITE COB LEDS, FOLDS IN HALF: Each panel carries 82 white COB LEDs plus 12 red ones, so two panels give you 164 white light beads across the full engine bay. Unfold to 28.74 in for wide coverage, fold to 14.96 in to fit a toolbox, and run one panel for close-up work or both to flood the whole bay
• HOLD 3 SECONDS, THEN JUST WAVE: Panel has its own switch and its own sensor. Hold that switch for 3 seconds to turn Sensor Mode on, then wave inside 0-10 cm to switch that panel on or off without touching the light. Sensor Mode shuts itself off after 1 hour, and once any mode has been held for 10 seconds a single tap switches that panel straight off - no clicking through all four modes
• 6000mAh AND FOUR REAL RUNTIME NUMBERS: One panel runs about 8 hours on high or 17 hours on low
• both panels run about 5 hours on high or 10 hours on low. A 4-level indicator shows what is left before you start, Type-C refills the battery in 5.5-6 hours, and the USB-A port reverse-charges your phone
• 5 WAYS TO HOLD IT, BOTH HANDS STAY ON THE JOB: Magnetic base for flat steel, hanging hook, upright stand, a stable triangle stand, or the carry handle. It weighs 1.46 lb and the hook rotates 360 degrees, so the light stays where you put it instead of staying in your hand
• HIGH WHITE, LOW WHITE, RED AND RED FLASH: Pick High White or Low White for close-up repair work, steady Red for low-glare visibility at the roadside, and Red Flash when you need to be seen. Any mode can run on one panel alone or on both panels together
• IP54 AND IK08 IN A GREASE-AND-DUST GARAGE: The ABS + PC + silicone housing is IP54 rated against dust and splashes and IK08 rated against impact, and the USB port cover seals the charging port when you are done. In the box: the G62 work light, a Type-C charging cable and the user manual
• MAGNETIC BASE COMPATIBILITY NOTE: The magnetic base needs an iron or steel surface. It will not hold on aluminum, carbon fiber, plastic, glass, or on curved and vibrating panels. Clean the surface first and add a second support before you mount it overhead