JW1FSN-DC12V AJW4211 Panasonic JW Series Power Relay, 1 Pack, 12VDC Coil 270 Ohm, 10A 250VAC/30VDC, 1 Form C SPDT, 5-Pin PC Board Through-Hole Solder Terminal, Sealed Non-Latching Miniature Relay

아마존 달러(USD) 가격을 각 날짜의 환율로 원화 환산해 표시합니다. 현재 환율 $1 = ₩1,460 (2026-07-27 기준)

상품 특징

• [MODEL & SPEC CHECK] Match JW1FSN-DC12V / AJW4211 before purchase. This 1-pack sealed JW Series power relay uses a 12VDC coil, 270 Ohm coil resistance, 1 Form C SPDT contact arrangement, 5-pin PC board solder terminals, and 10A 250VAC / 10A 30VDC resistive load rating
• [BOARD-MOUNT RELAY FUNCTION] Built for PCB through-hole relay replacement and control-board repair where the circuit calls for the same JW1FSN-DC12V style. Suitable for equipment, appliance, power module and industrial electronic boards only after confirming the original relay model, footprint and electrical ratings.
• [IDENTIFIER CROSS-CHECK] Key identifiers to verify: JW1FSN-DC12V, AJW4211, JW Series, 12VDC coil, 1 Form C, sealed, 10A high-capacity type. Housing markings may include SPULE: 12V and 10A 250V~ cosφ1.0; lot codes such as 51010Q are traceability marks, not replacement numbers.
• [INSTALLATION NOTES] Disconnect power and discharge the board before service. Desolder the old relay carefully, avoid lifting PCB pads, clean the solder holes, and install the relay squarely with all pins fully seated. Inspect nearby traces and terminals for heat, corrosion, moisture or loose solder joints.
• [IMPORTANT COMPATIBILITY] This listing is for one relay only. Match the complete part number, 12VDC coil, 270 Ohm coil resistance, contact arrangement, 5-pin through-hole footprint, size and ratings against the original board or equipment manual. Do not use if coil voltage, pin layout or contact form differs.

스펙 정보