G6B-2214P-US 12VDC 1 Pack DPST-NO 2 Form A 5A 250VAC/30VDC PCB Power Relay, 6-Pin Straight Through-Hole Solder Terminals, 480 Ohm Coil, Fully Sealed Miniature Relay

아마존 달러(USD) 가격을 각 날짜의 환율로 원화 환산해 표시합니다. 현재 환율 $1 = ₩1,463 (2026-07-27 기준)

상품 특징

• [SPEC & MODEL CHECK] Match G6B-2214P-US / G6B-2214P-US 12VDC / G6B-2214P-US DC12 before ordering. 12VDC coil, DPST-NO / 2 Form A, 5A 250VAC or 5A 30VDC resistive load, 480 Ohm coil resistance, 6-pin straight PCB solder-terminal layout. Verify the original relay marking, coil voltage, contact form and board footprint.
• [PCB POWER RELAY] Replacement PCB power relay for compatible control boards, timing circuits, output modules, power-management boards and other equipment that already uses the same G6B 2-pole 12VDC relay footprint. No vehicle fitment is claimed; confirm by board BOM or the original relay label.
• [CONTACT FORM CHECK] DPST-NO means two normally-open contact circuits close when the 12VDC coil is energized. Do not use it to replace SPST, SPDT, DPST-NC, latching, diode/indicator, reverse-polarity, high-capacity, FD, U, socket-mount -P6B or different-coil models unless the circuit design confirms equivalence.
• [FOOTPRINT & TERMINAL CHECK] Straight through-hole PCB terminals are intended for board mounting by soldering. Compare terminal count, pin spacing, relay height, clearance and relay orientation to the existing board before installation; this listing includes the relay only, not a socket, base or hold-down clip.
• [INSTALLATION NOTE] Disconnect power before service. Desolder carefully or remove the old relay straight from a matching PCB location without bending pins. Inspect solder pads, traces and terminals for heat damage, cracks, moisture or looseness, then test the circuit after replacement. Pack includes 1 relay.

스펙 정보