53ND12-Y-HW 12V 40A PCB Power Relay, 6-Pin DIP SPST-NO, 40125C, AgSnO2 - Compatible with FBR53-HW Footprint for 12V Automotive Modules

아마존 달러(USD) 가격을 각 날짜의 환율로 원화 환산해 표시합니다. 현재 환율 $1 = ₩1,463 (2026-07-27 기준)

상품 특징

• Specs & cross numbers — 12 V coil (code D12), 40 A @14 VDC resistive, 80 A inrush; AgSnO2 contacts; Form U (SPST-NO); sealed 6-pin DIP PCB relay; -40~125 C; operate/release <=10 ms; coil power 860 mW / 310 mW; approx. 12.3 × 15.7 × 14.0 mm. Cross/markings (identification only): 53ND12-Y-HW (case print); Compatible with FBR53ND12-Y-HW; Compatible with FBR53ND12-Y-HW-RW-F. Verify by the printed code and PCB footprint before purchase.
• Compatibility (component-level) — Compatible with 12 V modules that use a 6-pin PCB footprint compatible with FBR53-HW “ND12”. Typical board locations searchable by users: [Engine Bay Power Distribution PCB Relay] [Radiator Cooling Fan Module Relay] [A/C Compressor Clutch Control Relay] [Headlamp/DRL Module Relay] [Blower Motor Controller Relay] [Fuel Pump Driver Module Relay] [Body/BCM Power Relay]. Confirm by printed code 53ND12-Y-HW and the same pad layout.
• Complementary/related parts — Same footprint/contact system across coil options when specified by your board: Compatible with FBR53ND10-Y-HW (10 V coil), Compatible with FBR53ND09-Y-HW (9 V coil), Compatible with FBR53ND12-Y-HW-RW-F (reflow-capable). These are not electrical substitutes for 12 V boards unless coil voltage matches. Helpful tools: flux pen, desoldering braid, SAC305/60-40 solder, fine tip iron, conformal-coating touch-up.
• Symptoms this can fix — No-start (fuel pump not energizing), A/C not engaging, cooling fan inoperative/overheating, headlamps/DRL dead, intermittent BCM/ECU resets, melted/burnt relay, stuck contacts causing battery drain. Bench check: apply 12 V DC to the coil with current-limited supply, listen for click, confirm continuity across load pins only when energized; replace if coil is open, contacts show high resistance, or case shows heat damage.
• Complementary/related parts — Same footprint/contact system across coil options when specified by your board: FBR53ND10-Y-HW (10 V coil), FBR53ND09-Y-HW (9 V coil), and reflow-capable FBR53ND12-Y-HW-RW-F for THR assembly. These are not electrical substitutes for 12 V boards—match the exact coil voltage printed on the original. Helpful tools: flux pen, desoldering braid, SAC305/60-40 solder, fine tip iron, conformal-coating touch-up.

스펙 정보