MIN CI 초강력 희토류 자석 30개, 20 x 3mm 장식용 라운드 실버 네오디뮴 냉장고 자석, 공예, 화이트보드, 사물함용 다기능

상품 특징

• 6mm x 2mm 60 Pack
• 10mm x 3mm, 100팩
• 12mm x 3mm, 100팩
• 당사의 제품은 튼튼한 네오디뮴 자석으로 흡입력이 뛰어납니다. 필요에 맞는 다양한 크기가 있으며 맞춤형 크기를 지원합니다
• 3중 전기 도금은 자석의 외관을 더 내구성 있게 만듭니다. 크기 직경 20mm 두께 3mm, 생산 배치는 다양합니다. 0.4mm(0.00000000000000000000000000000000000000
• 일상 생활이나 작업, 공예, 주얼리, 사진, 인사말 카드 디스플레이, 자석 프로젝트 등에 널리 사용되는 자석
• 다기능 강력한 자석 푸시 핀: 사물함 자석, 냉장고, 달력, 지도, 주방, 빌보드, 가정, 사무실의 드라이 지우개 보드로 사용할 수 있습니다
• MIN CI 네오디뮴 자석 제조업체로, 다양한 크기의 자석을 제공할 수 있습니다
• We are committed to designing and developing magnets that provide the utmost in quality, dependability, and value.
• Our magnets don't just bring simplicity and convenience to your life, they offer all kinds of DIY experiences you want with zero restrictions
• 산업용 및 과학용 중 #6,134위 (산업용 및 과학용 에서 상위 100개 보기)
• not due to the cost - only a $25 antenna - but the 6 to 8 weeks of supply chain delays to acquire a replacement.Following examination of the debris, it was quickly determined that the tiny magnet used in the base during manufacture was woefully inadequate to hold it to the roof of a vehicle at highway speeds.A small mold was made to replicate the shape of the plastic base, the recovered fragments were placed approximately where they would have been before the accident, the metal parts were verified to still have electrical and RF integrity, and a small amount of resin was poured to reconstruct the base.The steel cup in which the original magnet had been placed, was measured for inside bottom diameter, as was its depth with a machinist's gauge. With sufficient cup clearance calculated to maximize magnetic field strength out of the bottom, these magnets were selected and ordered as the best fit and likelihood of sufficient strength to upgrade the base holding force to an acceptable performance level in the field.While the magnets were en route, the antenna system was tested with a rather expensive microwave antenna and feedline analyzer, and determined to be still functional within the cellular 4G spectrum.The empty cup was filled with JB Weld epoxy (which although it contains steel powder and is slightly magnetic, does not divert more than a few percent of magnetic flux). This was used to "pot" the magnet so when removing the modified rebuilt assembly from a car roof, it will stay firmly attached to the antenna and not the car.24 hours later once the epoxy had fully cured, the repaired unit was placed on the car roof, with a camera anchored nearby to observe it. The antenna analyzer was connected to