Plumb Pak Keeney 400WK 3.2cm x 3.8cm(1.25인치 x 1.5인치) 리듀싱 와셔 포함 플라스틱 P-트랩, 화이트, 3.2cm(1-1/2인치) 또는 3.2cm x 3.8cm(1-1/4인치 x 1-1/2인치)

상품 특징

• Industrial & Scientific
• Hydraulics, Pneumatics & Plumbing
• Image Unavailable Image not available forColor:
• 1-1/2-Inch or 1-1/4-Inch by 1-1/2-Inch
• 1-1/2-Inch or 1-1/4-Inch by 1-1/2-Inch (Pack of 4)
• 1-1/2 in. or 1-1/4 in. inlet
• 1-1/2 in. outlet
• Includes all necessary nuts and washers
• Connects to 1-1/2 in. or 1-1/4 in. wall connection with reducer washer
• Heavy-duty washer safeguards against leaks for a problem-free connection
• Durable polypropylene material
• P-trap for lavatory or kitchen
• Inlet: 1-1/2-Inch Or 1-1/4-Inch
• With 1-1/2-Inch to 1-1/4-Inch reducer washer
• Outlet: 1-1/2-inch
• White polypropylene
• #18,071 in Industrial & Scientific (See Top 100 in Industrial & Scientific)
• #371 in Pipe Fittings
• cut the new one to size
• and used a 2-sided slip joint connector in between the two cut pieces. This way, future vanity replacements will be easier. We also needed an extension piece for the upper part of the J section of the P-trap in order to reach the new sink drain (taller vanity).This project was definitely a learning experience for us. Everything was pretty easy to install. We used the 1-1/2” washers everywhere except where the extension meets the sink drain. This P-trap worked well with the two pieces we bought locally. No glue or plumbers tape or putty or anything else was needed. The nuts and washers create a good seal. We checked everything several times and couldn’t find any leaks. The quality / durability seems to match that of the many other white plastic plumbing parts. No surprises. The price seems good considering it’s delivered. Of course, we ended up needing to visit the store for the other pieces we needed… but that’s on us.Read moreRead less K+S in STL5 out of 5 starsA Standard 1-1/2” White P-TrapReviewed in the United States on January 8, 2026Size: 1-1/2-Inch or 1-1/4-Inch by 1-1/2-InchStyle: P TrapVerified PurchaseThis is a standard P-trap and worked quite well with other 1-1/2” components. The J part is a standard 3-1/2” on center. What makes it work for either 1-1/2” or 1-1/4” is the inclusion of two different washers (which is also fairly typical).We needed it because we installed a new vanity with a slightly different sink drain location. The horizontal arm of the existing P-trap was glued into the drain pipe at the wall and cut too short to reach the new sink drain. We really didn’t want to try to remove it and then have to glue the new one in its place. Instead, we cut the old one, leaving a little over an inch for the nut and washer
• and used a 2-sided slip joint connector in between the two cut pieces. This way, future vanity replacements will be eas