1 PK FPC Ribbon Cable for Bambu Lab H2S Extruder Filament Sensor Cable – Filament Jam Sensor Cable for H2S & H2S Laser 3D Printer Filament Runout and Cutter Position Detectio

["【Direct Replacement for H2S Extruder Filament Sensor Cable】This FPC ribbon cable is designed to replace the damaged or worn cable that connects the filament hall sensor board to the mainboard on Bambu Lab H2S and H2S Laser 3D printers. It restores both filament presence detection and cutter lever position monitoring","【Solves Common Filament Detection Errors】If your H2S printer shows false filament runout warnings, fails to auto-pause when filament runs out, or the filament cutter does not trigger correctly, the ribbon cable is often the root cause. Replacing this cable eliminates intermittent connection issues caused by repeated bending","【Standard Flat Flexible Cable for H2S Extruder Assembly】Manufactured to match the electrical requirements of the H2S extruder filament sensor system. The flexible design allows easy routing along the extruder cable path, even in tight spaces inside the H2S enclosure","【Easy Installation – No Soldering Required】Simply disconnect the old ribbon cable from both the hall sensor board and the motherboard connector, then plug in this new cable. No special tools or soldering needed. The cable is pre-cut to the correct length for a clean fit inside the H2S extruder housing","【Compatible Models】Designed specifically for Bambu Lab H2S and H2S Laser 3D printers. This cable is used for the extruder filament sensor (hall effect board assembly). Please verify that your original cable looks identical before ordering"]